Troubleshooting - cecotec StrongTitanium 19000 Manuel D'instructions

ENGLISH
before taking the jar away from the nozzle.
7. Take the jar away from the juice nozzle after the motor and sieve have stopped completely.
Switch positions
0: Off
1: Low gear for soft fruits and vegetables, such as watermelon, tomato, cucumber, and
strawberries.
2: High gear for hard fruits and vegetables, such as carrot, pear, celery, etc.

4. TROUBLESHOOTING

Problem
The product does
not work when
turning on the
switch.
The product emits
an unpleasant
smell when
switched on for
the first time.
The appliance
stops while in use.
Too much pulp in
the juice
Abnormal
vibration or too
much noise
STRONGTITANIUM 19000
16
Possible cause
1. The central ring is not properly
placed.
2. The top cover is not properly
installed.
3. The top cover is broken.
This is normal.
1. Low voltage level.
2. Excessive amount of food.
3. Too much pressure exerted
with the press.
4. Temperature control
protection of the motor.
1. Broken sieve.
2. Too much pulp in the central
ring.
1. Improper installation of the
sieve or the appliance is not
placed in an even surface.
2. The appliance is not placed in
an even surface or a footpad is
missing.
3. High voltage level.
4. Excessive amount of food.
Solution
1. Install the ring properly.
2. Install the top cover properly.
3. Replace the top cover
If the juicer still emits an unpleasant
smell after several uses, contact the
Technical Support Service of Cecotec.
1. Check whether the voltage is too
low.
2. Turn off the power to remove some
food from the feeding tube.
3. Do not press as hard.
4. Resume operation after 20-30
minutes.
1. Replace the sieve.
2. Clean the central ring.
1. Install the sieve in place.
2. Put the product in an even surface
or install the footpad in place.
3. Check whether the voltage is too
high.
4. Turn off the power to remove some
food from the feeding tube.