Operating The Power Mixer; Operation; Working Position - Robot Coupe CMP 250 V.V. Notice D'instruction

INTRODUCTION TO YOUR
NEW ROBOT-COUPE
POWER MIXER
Robot-Coupe has developed a complete line of
power mixers. The features of each are described in
the table below.
Variable
Models
speed
•
CMP 250 V.V.
•
CMP 300 V.V.
•
CMP 350 V.V.
•
CMP 250 Combi
•
CMP 300 Combi
The Robot-Coupe Power Mixers perform a host of
culinary feats. The mixer attachment will allow you
to make soups, vegetable purees and pulps while
the whisk attachment is ideal for making pancake
batter, mayonnaise, beaten egg whites, chocolate
mousse, butter sauces, whipped cream or smooth
fromage frais.
The variable speed function will enable you to ad-
just the speed to suit each preparation and to start
the processing at a lower speed in order to reduce
splashing.
The power mixer is easily assembled and disassem-
bled for maintenance and cleaning.
OPERATING THE
POWER MIXER
•

Operation

The power mixer is equipped with electrical current
and temperature overload protection. If the power
6
mixer stops unexpectedly you may try to restart it
by following steps 3-5 below. If the power mixer
does not restart, allow it to cool for a period of up
to 30 minutes and the temperature overload will
automatically reset. You should then be able to
restart following steps 3-5 below.
1. Check that the control
button (CB) is in the re-
Mixer Whisk
leased position.
attachment attachment
2. Connect the cord to
•
the power supply
•
3. Put the tube into the
•
product with the bell
completely immersed
• •
and the splash guard in
• •
place.
4. Press and hold down
the safety button (SB).
5. Press the control but-
ton (CB) and the power
mixer will start.
6. Release the safety
button (SB).
7. To stop the power
mixer,
control button (CB).
• Continuous operation
8. Follow steps 1-6 above, then: While the control
button (CB) is pressed, press the locking button (LB).
9. Release the control button (CB).
10. Release the locking button (LB), and the power
mixer will run continuously.
11. To stop the power mixer, press and release the
control button (CB).
SB
VS
release the
• Variable-speed operation
Follow steps 1 to 6 above, then change the speed of
the motor by turning the button (VS) toward the
maximum or minimum as required.
It is advisable to start at a low speed when using
the whisk.
CB
• Mixer operation
LB
Hold the blender firmly
by the handle and the
bottom of the motor unit
and tilt it at a slight
angle. Move the mixer
around in the container
for complete processing.
The power mixer can be
rested against the rim of
the container but must be
tilted so that it does not
touch the bottom of the
container.
If using the power mixer
support (optional acces-
sory), on the top of the
container, the power
mixer should be positio-
ned in the middle of the
support and at a slight
angle. Do not operate
the power mixer with
the bell straight up-and-
down against the bot-
tom of the container
The splashguard should always be in place.

WORKING POSITION