PSI Woodworking PKTST Serie Guide Rapide page 4

#PKTSTXX
Head Stock
7mm Spacer
Bushings
Turning the Blank
• Mount the bushings and blanks according to diagram B.
• Thread on the knurled nut and hand tighten to hold all components in place.
• Slide the tailstock up snugly against the mandrel shaft inserting the live center point into the mandrel
dimple, lock in place.
• Hand tighten the quill adjustment to firm up the mandrel. (DO NOT overtighten, it could damage the
mandrel.
• Using sharp tools, turn the blank down close to the bushing diameter. Turn the barrel (straight or to a
profile of your choice)
• Sand the blank down to be flush with the bushings gradually increasing the sandpaper grits.
• Finish the barrel with your choice of polish. Allow sufficient time for the polish to cure.
- refer to polish instructions.
Assembly
• Layout parts according to diagram A
• Insert the clip assembly into either end then of the barrel, press in.
• Insert the nut into opposite end press in.
• Thread on the soft-tip into the nut
• The stylus is now ready to use
DIAGRAM B / TURNING THE BLANKS
Tube
End Bushing
Diagram C / Bushings #PKM-BUSH3
.375"
ø.330"
© 2011 PSI Woodworking Philadelphia PA 19115 - v10/12
Blank
Barrel
.375"
ø.330"
PSI Woodworking Products
Knurled Nut
Live Center
End Bushing
Mandrel
7mm Spacer
Bushings
.248" hole through