PSI Woodworking PKTST Serie Guide Rapide page 3

#PKTSTXX
The Stylus Kit
Kit Features:
• East to turn with a straight tube.
• Minimum parts - easy to assemble
• Available in multiple finishes
• Overall length 4-9/16"
• 7mm tube
• Works with tablets and smart phones.
Required Accessories:
• 7mm, Pen Mandrel
• 7mm Drill Bit, #PK-7MM
• 3 pc Bushing set #PKM-BUSH3, uses 2 of 3 in the set,
• Barrel Trimmer set #PKTRIM7
• Live Tailstock Center
• 2 Part Epoxy Glue or Insta Cure (Cyanoacrylate) Glue
• Pen Blank: Minimum Size- 5/8" x 3/1/2"
Stylus Soft-tip
Preparing the Blank:
• Cut the blank to the length of the tube add 1/16" for squaring off.
• Drill a 7mm hole lengthwise through the blank.
• Spread glue over the tube, insert the blank with a twisting motion to spread the glue evenly inside.
Center the tube lengthwise inside the blank.
• When the glue is dry, square the ends of the blank. Use a 7mm barrel trimmer or a universal
pen blank squaring jig with a power disc sander. Take the excess material down flush
with the ends of the brass tube. Use a barrel trimmer to clean the inside of the tube.
Trouble shooting: Problem - your touch stylus does not work on a touch Screen
The stylus tip control over a touch screen is activated by the electric conductivity from your finger, through the stylus tube to the rubber
tip - this small electrical charge enables the stylus to work. If it does not work try these remedies.
Check your fingers: If you (or the user) have on gloves or other finger protection take it off. If fingers are covered with glue from assem-
bly - remove the glue. Check to see if your fingers work without the stylus. If it does not then the problem is probably not the fault of the
stylus.
There must be good connectivity between your fingers and the stylus tip through the tube inside of your kit. You may get poor connec-
tivity if you split the tube, or the components are not properly pressed with excessive glue. The easiest way to remedy this is to fold a
piece of silver foil and insert into the tube so it presses both front and rear ends to complete all possible poor connections..
Remove the tip and try another tip. If the original tip is defective, call the company for a replacement.
DIAGRAM A / PARTS LAYOUT
Nut
3-3/16"
Tube / Barrel
PSI Woodworking Products
Clip Assembly