Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Do not expose cells or batteries to heat or fire. Avoid storage in direct
sunlight.
• This product may only be serviced by a qualified technician for maintenance
to reduce the risk of electric shock.
• Do not short-circuit a cell or a battery.
• Clean the product regularly with a soft, clean, dry cloth. Avoid abrasives that
can damage the surface.
• After extended periods of storage, it may be necessary to charge and
discharge rechargeable cells or batteries several times to obtain maximum
performance.
• Unplug the product from the power source and other equipment if problems
occur.
• Do not expose the product to water or moisture.
• Do not unplug the product by pulling on the cable. Always grasp the plug
and pull.
• Consult the local laws and regulations for this product before installing and
using.
• Only use the provided USB charging cable.
Charging the product through micro USB
1. Plug the micro USB cable A
2. Plug the other end of A
Wired connection
1. Loosen the screws of the external power input A
2. Hold one of the 12 - 24 VAC wires behind the metal plate of A
3. Tighten the screw of A
4. Hold the other 12 - 24 VAC wire behind the other metal plate of A
5. Tighten the last A
connection.
Mounting the product (image B)
1. Hold the bracket A
2. Use A
2
to mark the drill locations with a pencil.
3. Remove A
2
wall type.
4. Insert the plugs A
into the micro USB port A
q
q
into a 5.0V/1.0A USB adapter (not provided).
t
to connect the wire to the doorbell.
t
screw to complete connecting the 12 - 24 VAC
2
against the wall where you want to install the product.
and drill the holes, using a drill with appropriate drill bit for the
into the holes.
o
t
.
6
.
4
.
t
.
t
Publicité
Table des Matières
