Bond HYPH4601-2 Guide D'utilisation page 4

SAFETY INFORMATION
Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied
directly by Bond Manufacturing Co., Inc..
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate
the appliance. For assistance with repair or replacement of the burner or any other parts, call Bond
Manufacturing Co., Inc. at 1-866-771-BOND (2663) | Help available in English and Spanish Monday -
Friday, 8:00am - 4:30pm PST
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
valve is turned "OFF" before assembling. Do NOT attempt to assemble without proper tools.
Min. Clearance
61 cm / 24 in
Min. Clearance
61 cm / 24 in
Bond Manufacturfing Co., Inc. | Page 4
BE CAREFUL: WHEN CERTAIN MATERIALS OR
ITEMS ARE STORED ABOVE, BESIDE OR UNDER
Min. Clearance
THIS HEATER WHILE IN USE, THEY WILL BE
61 cm / 24 in
SUBJECT TO RADIANT HEAT AND COULD BE
SERIOUSLY DAMAGED.
Combustible materials should not be within 61
cm / 24 in of the top of the unit, or within 61 cm
/ 24 in around the entire unit.