Before First Use; Mounting; Using - Inventum Silhouette SC400 Mode D'emploi

• the appliance is only intended for household use.
• do not use the device outdoors.
• If the appliance is used for other purposes than
intended, or is it not handled in accordance with the
instruction manual, the full responsibility for any
consequences will rest with the user. any damages to
the product or other things are not covered by the
warranty.
2 | before first use
Before you use the appliance for the first time, please do
as follows: carefully unpack the appliance and remove
all the packaging material. Keep the material (plastic
bags and cardboard) out of reach of children. check the
appliance after unpacking for any damage, possible from
transportation. place the appliance on a flat and stable
surface.
rinse all the accessories ­ food pusher, lid, filter and
pulp container ­ with warm soapy water and dry them
thoroughly. Wipe the base with a damp cloth. always roll
out the cord completely.

3 | mounting

1. place the base (8) on a flat and stable surface.
2. check that the unit is switched off.
3. place the filterholder (5) on the base.
4. mount the filter (4) on to the filterholder by pressing
firmly. Ensure it is fitted securely inside the
filterholder.
5. place the lid (3) over the filterholder by fitting the
small opening in the back of the lid on to the notch
the filterholder.
6. place the food pusher (1) into the feed chute.
groove in the pusher with the small protrusion on the
inside of the feeding tube.
7. raise the locking handles (8) up over the lid. place the
tops of the locking handles on the lid and then push
them into place to the sides of the juice extractor.
the unit does not operate if the handles aren´t
properly locked.

4 | using

the juice extractor will only operate when all the
parts are in position and the locking handles are locked
properly.
you can preferably use fruits/vegetables directly from
the refridgerator if you like cold juice. clean fruit and
vegetables thoroughly. remove big stones (for instance
peaches, cherry and apricots), apples and pears can be
added whole without removing the core. Ingredients with
thick peel (like melons, pineapple, cucumber) as well as
citrus fruits should be peeled first; otherwise the filter
can be damaged. cut too large fruits/vegetables once or
several times to fit the feed chute. also remove stalks and
bad parts.
1. Before plugging into a socket, check that the voltage
in your home corresponds with the voltage printed on
the bottom of the appliance and connect the plug to
wall socket.
2. choose the desired speed by pushing the speed control
to position 1 or 2. use the below guide lines:
Speed 1: tomatoes, pears, peaches, strawberries,
oranges, plums, grapefruits, lemons, cherry, currant,
gooseberries, onions, cucumbers, garlic, parsley.
Speed 2: carrots, apples, pepper, potatoes,
pineapple, cabbage, celery, spinach, fennel and other
root vegetables.
3. place a glass under the spout.
4. press the fruit­ and/or vegetable pieces slowly down
the feed chute with the pusher.
since speed and extraction will be influenced
negative. The motor shall always be operated while
the fruit and vegetables are being pressed down in
the opening. The juice will now rinse down in the glass
and the leftovers will be thrown into the pulp
Align the reservoir. Cut too large fruits/vegetables once
or several times to fit the feed chute.
5. If anything gets stuck so that the extractor operates
slow or stops, the appliance must be switched off and
the filter cleaned.
6. always switch off the appliance after use by pushing
the speed control to "0". Wait 10-15 seconds until
the filter stops rotating. Let the last drops of juice
rinse down into the glass and then unplug the appliance
from the wall socket.
Attention: always switch off the appliance and wait 10­
Attention: never use your fingers, when pushing down
Attention: the juice extractor must only be operated
14
Do not push too hard,
15 seconds until the filter stops rotating
before you open the device.
fruit and vegetables in the opening. always
use the pusher only.
during 1 minute at a time, then a pause to let
the machine cool down to room temperature
before using it again.