INSTALLING PUMP KIT
4
INSTALL NEW DRAIN TUBING
Install the new white drain tubing in the
accessories to the drain pump and clamp with the
snap ring included in the kit.
Snap Ring
White Drain
Tubing
5
INSTALL THE DRAIN PUMP
Insert the red connector of the drain pump into the
red connector you will see on a wire inside of the
ice machine.
Red Connectors
Slide the drain pump into the ice machine so the
base slides under the tab on the base of the ice
machine floor. The front of the pump with the hose
attached will face the front of the ice machine.
31-1000617 Rev. 2
Installation Instructions
(Cont.)
Tab
5
INSTALL THE DRAIN PUMP
(Cont.)
Using the hardware from the kit, attach the pump
to the ice maker floor using a wrench.
6
CONNECT DRAIN PUMP TO ICE
MACHINE
Slide the small metal clamp, which you saved
from original tube assembly, on the short drain
tube of the PVC drain pipe as shown in the picture
below. Push the pipe up to connect both tubes
to the fittings from the ice machine which you
disconnected earlier. Snap and secure the snap
ring back on the connection of the main drain tube.
Slide up and secure the small metal clamp up and
tighten at the connection.
3