Proper Torque Is Needed To Keep The Hitch; Secure To The Vehicle When Towing - Horizon Global 75998 Instructions D'installation

7. Raise hitch into position, over the exhaust, and feed the pull wires through bracket slot. Remove pull wires and loosely install conical washer ③, hex nut ④, lock washer ⑦ (if needed) and M14 bolts
(Trailhawk only) to the hitch. NOTE: Remove the seam sealer on the side of the frame for proper fitment. Double check if the trim area is enough for the hitch. Make additional trimming if needed.
8. Tighten all ½-13 GR8 fasteners with torque wrench to 110 Lb.-Ft. (149 N*M) and all M14 CL 10.9 fasteners to 148 Lb.-Ft. (201 N*M).
9. Use cable ties ⑥ to secure vehicle wiring to exhaust hanger bracket.
10. Reinstall bottom plastic panel, lower fascia, and exhaust removed in step 1, 2.
©2015-2018 Horizon Global™ Corp - Printed in Mexico
Trailhawk
Sheet 7 of 21

Proper torque is needed to keep the hitch

secure to the vehicle when towing.

75998NP 10-10-18 Rev. E