AquaCraft 290110 Instructions page 3

AUTOMATIC WATER TIMER INSTRUCTIONS
EN
Dear Customer:
We thank you for buying one of our products and we wish it will fully
satisfy your needs. Please note the following instructions:
1. Insert one 9V Alkaline battery.
2. Press the SET button once.
3. Enter the correct hours in the CLOCK by pressing the UP and
DOWN buttons and then press the SET button.
4. Enter the correct minutes in the CLOCK by pressing the UP and
DOWN buttons and then press the SET button.
5. Enter today's day as a number ( i.e. 1 = Monday, 2 = Tuesday and so
on) and then press the SET button.
If you want to get immediate watering, just press the DOWN button it
will start to give water immediately. Press the DOWN button again it will
stop the original program you have set remains unchanged.
NOTE: if you make no other entries for one minute the built-in
automatic program will be activated and the watering will start everyday
at 7:00 for a duration of 20 minutes and then at 18:00 for another 20
minutes.
If this built-in automatic program does not meet your watering needs
then continue with the following steps to set up your preferences in
TIMER 1 and TIMER 2.
6. Press the SET button and enter your watering start time in TIMER 1,
first the hours by using the UP/DOWN and finally the SET button.
Then use same procedure to set up the minutes and the watering
DURATION in minutes.
7. By same procedure set up TIMER 2.
8. In order to set up the watering days for each number from 1 to 7
press the SET button to accept the day as watering day or press UP
or DOWN button to avoid watering on this day and then press SET.
Programming is now completed.
During watering cycle if you wish to shut the valve off press the
ON/OFF button once, if you wish to restart again press the ON/OFF
button again.
When appears in the screen it is time to replace the buttery.
During Winter it is advisable to take this product indoors to avoid any
damage from freezing.
For any further information do not hesitate to contact your dealer.