Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Step 11
6
Align the holes in the back panel (H) with the
holes of the solid back (E). Using eight screws
(6), screw the back panel onto the solid back.
Do not fully tighten. Align side edges with
edge of left and right (A&B) and nail straight
into back edges as shown. Now fully tighten
the screws.
littleseedskids.com
10
x16
x8
#A21110
#A12120
2 people are required for this step.
Carefully turn the unit over onto its front as shown.
Assure that the unit is square.
Distance from corner to corner must be equal as shown.
H
E
D
19
6
Back panel notch location here.
A
IMPORTANT! THE BACK PANEL IS
A STRUCTURAL PART OF THIS UNIT
AND MUST BE INSTALLED PROPERLY.
10
Publicité
Table des Matières
