Appliance Operation - MOA CMF01 Manuel D'instructions

EN

APPLIANCE OPERATION

1. Unpack the package
Carefully remove the appliance from the packaging and keep the
packaging for future reference. Place it on a firm and level surface. In
the unlikely event of finding any damage to the appliance please return
it to the retailer
2. Startup
- This operation must be carried out before the machine is connected
with the electricity
- Remove the tank cover (B). Remove the water tank (D) and fill it
with fresh clean water of normal temperature, pure water is strongly
recommended to avoid scale in the machine, preferably with low
limestone content. The water level should no higher than the MAX
position
- Please make sure the water tank (D) is replaced correctly
- Replace the tank cover (B)
The device is now ready for making coffee.
3. Coffee/Espresso
- Power Switch (E).
Turn on the power switch, both coffee buttons indicating lights turn to
solid red, it starts preheating. When the correct temperature is reached,
both indicators turn to solid blue, then the machine is ready for coffee
making
- Making coffee.
Place a cup under the coffee spout (K). In case you choose Lungo,
remove the upper support (G). Open the capsule insertion door (C) by
Lever (A) and place a desired drink capsule into the Capsule insertion
door (C). Close the capsule insertion door (A) completely. Push the
button for the requested coffee; Espresso for a small cup and Lungo
for a larger cup (F/N). Once the desired quantity of drink has been
reached, the appliance will stop working. When the process is finished,
the used capsule will drop down into the container (M) after lifting the
lever.
If the capsule is not put into the correct position please turn off the
power switch, then open the door and repeat the previous process
Coffee Machine - English manual 6