NARDA SignalShark 3330 Consignes D'utilisation Et De Sécurité page 73

Fig. 11: Mounting the wall-mount adapter to the Outdoor Unit
1. Mount the two L brackets to the designated holes in the Outdoor Unit
using the cylindrical head screws. Note that spring washers are used
here.
2. Place the Outdoor Unit with the mounted L brackets against the wall in
the desired position, mark the mounting holes and, if necessary, drill pilot
holes.
3. Mount the L brackets on the wall using the appropriate materials. Use
washers with a large enough outer diameter.
8.2 Mounting the Outdoor Unit on a mast or pole
The mast-mount adapter for mounting on a pole or mast with a diameter of
NOTE:
48 mm to 200 mm is available separately (item no. 3330/90.07).
Tools required (not included in the kit)
• Allen wrench(AF 5 mm)
• 2 x open-ended spanners (AF 19 mm for M12 hexagon nut)
• Ring spanner (AF 19 mm, straight or offset)
Narda
SignalShark 3330 Outdoor Unit 73