König Electronic PA-SMA1202 Mode D'emploi page 5

1. Fuse holder/ voltage selector and main power connector
Required voltage has to comply with the voltage of the main circuit.
2. Power switch
The power switch puts the speaker into operation.
3. Main inputs
Line/ microphone inputs.
4. Aux input
All speakers have an unbalanced RCA aux input. If main and aux input are connected
simultaneously both inputs will be heard.
5. Line output
This output is directly connected to the inputs of the SMA speaker. It's possible to use
this to loop the input through the input of another device like a second SMA speaker.
6. Power and clip LED
The power LED will illuminate when the system is in operation. If the speaker is
overloading the clip LED illuminates, immediately decrease the input or volume level to
avoid damage to the speaker.
7. Volume level
Gives overall control over the volume level of this speaker.
8. Mic level
Gives control over the level of the microphone input.
9. Line level
Gives control over the level of the line and aux input.
10. Tone/bass and treble EQ
By turning the treble control knob to the left the high frequencies will decrease, by
turning right the high frequencies will increase. The bass control works the same way as
treble control.
11. Rear panel SMP series
Use SPK cables from your amplifi er output to the SPK socket of your speaker. The
second SPK socket can be used for looping speakers. Always check the minimum
impedance of your amplifi er fi rst.
5