Publicité
Les langues disponibles
Les langues disponibles
ST 07160 D BL/ST 07260 D BL/IN
Ventilation air inside: Turn the dial inside position (Dib 7B), install the outlet cover, turn on the fan, then the
air can be expelled from the inside out.
THE CLASS 1 HOOD MUST BE EARTHED
The connection should be made as follows:
BROWN
BLUE
YELLOW/GREEN
THE CLASS 2 HOOD MUST NOT BE EARTHED
Second class hoods with the characteristics label containing the double square symbol.
The connection should be made as follows;
BROWN
BLUE
(5) OPERATION
Using the control panel (Dib 8):
1. Press the Stop button to stop the engine.
2. Press the button to select Low low speed.
3. Press the button to select Mid average speed.
4. Press the button to select High speed.
5. Press the Light button to turn both lights. Press the button again to turn them off.
(6) MAINTENANCE
Change and filter cleaning
- Remove the filters as shown in pic 9.
- You can clean the filters as shown below:
1. Soak for about 3 minutes in hot water (40-50 degrees) with detergent grease remover after gently clean
them with a brush. Do not apply too much pressure to avoid damage.
2. They may be in the dishwasher with detergent, at a temperature of 60 degrees.
- Do not use an abrasive detergent in them could damage the hood.
- Make sure the hood is off before cleaning.
=
L (live)
=
N (neutral)
=
Earth
=
L (live)
=
N (neutral)
12
Publicité
