Final Assembly; Troubleshooting Guide - HeathCo HeathZenith 8485 Mode D'emploi

FINAL ASSEMBLY

1. Push the wires into the junction box.
2. Slide the fixture assembly onto the long fixture screws.
Tighten decorative nuts securely against fixture base.
3. Caulk the fixture base mounting surface with silicone
weather sealant.
4. Adjust lamp holder(s) as needed. Note: Loosen
the screws on the lamp heads before making any
adjustments. IMPORTANT: Do not rotate the lamp
holders more than 180° from the factory setting.
Decorative Nut
Power Requirements .... 120 VAC, 60 Hz
Wattage ........................ Model 8487 - Max. 8 Watt LED
LUX control level ........... Approximately 20 lux
HeathCo LLC reserves the right to discontinue products and to change specifications at any time without
incurring any obligation to incorporate new features in products previously sold.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
CAN ICES-005 (B)/NMB-005 (B)
SYMPTOM
Lights will not come on.
Lights stay on continuously.
Lights flash on and off.
206151-04
Long Fixture Screw
Junction Box
SPECIFICATIONS
Model 8485 - Max. 2 x 10 Watt LED

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
1. Light switch is turned off.
2. Fuse is blown or circuit breaker is turned off.
3. Daylight turn-off is in effect.
4. Incorrect circuit wiring, if this is a new installation.
Light control is mounted in a dark location.
Light control may be sensing shadows.
TEST AND ADJUSTMENT
1. Turn on the circuit breaker and light switch.
2. To test the light during daylight, cover the photocell
with black tape and ensure the light works properly.
3. Monitor light control to verify that the lights come on
at night and turn off during the day.
4. Adjust lamp holder(s) as needed.
SOLUTION
1. Turn light switch on.
2. Replace fuse or turn circuit breaker on.
3. Recheck after dark.
4. Verify wiring is correct.
Relocate light control to an area that receives more light.
Relocate light control to an area away from shadows.
3
Photocell