The Transmitter After The Dive - Seac Guru HP Manuel De L'utilisateur

The Transmitter after the dive

The Transmitter shuts off automatically 30 seconds after you close the tank and have drained the pressure remaining in the first
stage.
Use only fresh water to clean your Transmitter, removing all saline deposits. Surfactants and solvents must be strictly avoided.
Only wash the Transmitter when it is connected to the first stage. Do NOT wash the Transmitter if the first stage connector
hole is not properly protected against the water.
When disassembled from the first stage, put the protective cap on the Transmitter. Leave it to dry, shielded from the rays of the
sun, and do not use jets of cold or hot air.
You can leave the Transmitter mounted on the first stage or remove it.
If you decide to leave it mounted, make sure it is not exposed to any blows. Refer to the Warnings and the "care and maintenance"
chapter of this manual.
If you decide to disassemble the Transmitter, make sure you close its threaded connection hole using the special cap. (Refer to the
manual for your regulator regarding how to protect the first stage HP hole.)
16 English
m WARNING!
m WARNING!