Connecting The Transmitter To The Guru - Seac Guru HP Manuel De L'utilisateur

TX ID:
TANK RES:
RESET
EXIT
C
Next value
0.0
0
:00
MIX RBT
21 ---
10 English

Connecting the Transmitter to the GURU

Once the Transmitter is turned on, access the TRANSMIT menu on the
GURU by pressing the button on the bottom left of the watch screen and
scrolling through the menu items.
B
To pair with the Transmitter for the first time, position the GURU
OFF
approximately 20-30 cm from the Transmitter.
SRC
30
Placing the GURU too close to the Transmitter could prevent them from
pairing correctly.
D
Decrease
value
Press the
pairing is complete, the Transmitter's TX ID will be displayed on the screen.
(Each Transmitter has 31 TX ID communications channels. The TX ID is
assigned to the Transmitter randomly. You can change the Transmitter TX ID
if there is interference with another Transmitter; see the dedicated section
in this manual.)
To check that the GURU has paired correctly with the Transmitter, activate
OC
dive mode. Within 30 seconds, the tank pressure will be displayed in the
lower right part of the screen (BAR). (The RBT value will only be displayed
during the dive; see the dedicated section in this manual.)
Once paired, the GURU and Transmitter will connect automatically as soon
as the GURU activates OC (Open Circuit) dive mode.
BAR
---
Using the Transmitter reduces the GURU's batter y time to
approximately 20 hours of dive time. Set the TX ID to "OFF" if you are
not using the Transmitter.
m WARNING!
DISPLAY
20-30cm
SYS SET
PC MODE
TRANSMIT
B button to begin searching for the Transmitter (SRC). When
m WARNING!