E-Mu 1212M Mode D'emploi page 5

Power Converter Cable
To Power
To Disk Drive
E-MU 1010 PCI Card
A Line
Mic
B Line
Mic
Clip
-10 dB
Line - -10 dB
Mic -
+20 dB
-10 dB
+20 dB
Step 4: Connecting Internal
Power for the AudioDock
1. Locate the supplied Power Converter cable. Insert the small
Supply
2. Connect the other end of the power converter to an available
3. Replace the cover to your computer.
4. Plug the power cord and your peripheral devices into your
Rubber Feet
Four rubber feet were included with the AudioDock. These feet
should be used if you're not going to rack mount the AudioDock. If
you are going to rack mount the AudioDock, leave the feet off.
To install the rubber feet, simply peel off the protective backing from
Clip 48V
MIDI
-10 dB CLOC K
SMPT E
1 LCK
44.1 96
IN
MIDI 1
2 the adhesive and press the feet into the round depressions at each
2 EXT
48 192
OUT
S/PD IF
corner of the bottom plate.
In
Out
Out
Rack Mounting the AudioDock
The AudioDock was designed to be rack mounted using standard 19-
inch rack shelves. These shelves are available from a number of
manufacturers. (Search for "rack shelves" on the web.) Two
AudioDocks fit side by side on a single rack shelf. Two screws are
provided to secure the AudioDock to the rack shelf (M3 x 6mm). Do
not use screws longer than 6mm or damage to the circuit board may
result.
white connector into the audio card's power connector.
power supply cable from your computer's power supply unit.
(The other plug on the cable is only used if you don't have an
available power connection in your computer.)
computer and turn on your computer.
Getting Started - 5