Replacing The Activated Charcoal Filter; Light Replacement - Falcon FEXT720 Manuel D'instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Activated charcoal filter (Recirculation version)

• The filter is not washable and cannot be regene-

rated. It must be replaced when led S1 flashes

or at least every 4 months. The alarm signal

will only light up when the extractor motor is

switched on.

Alarm signal reset

• Switch off the lights and extractor motor.

• Press button T3 for at least 3 seconds, until the

leds start to flash.

Replacing the Filter

• Remove the grease filters.

• Remove the saturated activated charcoal filters

as shown (A).

• Fit new filters (B).

• Replace the grease filters.

Alarm signal activation

• In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or at a

later date.

• Turn the Lights and the suction Motor off.

• Disconnect the Hood using the Main switch or the double-pole switch on the mains power sup-

ply.

• Restore the connection by pressing and holding T1.

• Release the button. All five LEDs are turned on

• Within 3 seconds press T1 until LEDs T1 and T4 flash in confirmation:

LED flashes twice - Activated charcoal filter saturation alarm ENABLED

LED flashes once - Activated charcoal filter saturation alarm DISABLED

50 W halogen light.

• Remove the 2 screws fixing the light cover.

• Remove the lamp by gripping the protruding

part and turning to the left.

• Replace with a new lamp with the same cha-

racteristics, making sure that you insert the two

pins properly into their housings.

• Replace the cover and fix it in position using

the two screws removed as above