RC System Trixx 350BL Mode D'emploi page 4

Set Up Procedure
1. Factory default setting:
Initial voltage 55% battery discharge + Auto motor timing + No brake.
The only parameter to be programmed of the TRIXX ESCs is the brake.
Auto timing and cut-off haven't to be programmed.
2. Brake Mode Setting
This section offers 2 options switching, no brake and soft brake. The motor will come up with the
corresponding tones as indicator. The following is the indication with graphic reference:
I. Shifting throttle position to the maximum/full throttle.
II. Power on the transmitter/radio controller.
III. Connect the battery wire to the electronics speed controller, when entering programming mode you can hear 4
tones (like ♪♪♪♪), then shifting the throttle stick to the minimum/stop position.
IV. The electronics speed controller will come up with acknowledge tones ♪♪♪.
Then you could simply shut down the power. The mode will be switched and stored into the
microprocessor when the throttle stick is in the confi rmation position.
The controller is now ready to let you fl y.
Caution!!
High power motor systems could be very dangerous. High current could generate heat on wires, batteries, and
motors. Always follow the instruction and use proper tools to set up the system within safe range. Always fl y at
a designed fi eld with caution even though this controller is equipped with safety arming program.
The battery MUST be connected to the ESC with the right polarity. DO NOT change the polarity, otherwise you will
dramatically damaging the regulator and the battery, even causing fi re, letting the warranty decade.
DO NOT use a battery pack different from the one indicated in the technical specifi cations
DO NOT overcome the amperage drawn indicated in the technical specifi cations. Not doing this will cause a damage
of the ESC and will let decade the warranty.
RC System is trademark of the companies:
Safalero S.r.l. (Italy)
Model Racing Car (France)
Amerang Ltd (UK)