Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2b.) Underside of rear bumper fascia arear - Using a T25 star driver
remove (4) button head screws from underside of bumper fascia. Set
fasteners and heat shield aside to be reinstalled.
2d.) License Plate area - Using a T25 star driver remove (2) screws. Set
fasteners aside to be reinstalled.
©2020 Horizon Global™ Corp - Printed in Mexico
2c.) Rear wheel well area - Starting on driver side. Using a T25 star driver
remove (4) screws from rear side of wheel well. Repeat for passenger
side. Set fasteners aside to be reinstalled.
2e.) Using a plastic trim tool, partially remove the fascia by gently pulling
rearward while releasing the clips of the wheel well trim. Only remove as far as
shown in Figure 2
Sheet 5 of 24
76338NP
06-17-20
Rev. A
Publicité
Table des Matières
