Fitwood LUOTO Manuel Du Propriétaire page 2

Foreword
EN
Thank you very much for choosing the FitWood GALDHØP climbing arch. Please read this guide
thoroughly before assembly and follow each process step by step so you can enjoy the product
safely.
Please keep this guide for future reference. Should you need assistance with assembly, contact us
directly.
FitWood Ltd.
Hautalankatu 20
33560 Tampere
Finland
info@fitwood.com
https://fitwood.com
DISCLAIMER:
Read all instructions before using the product and follow assembly instructions accordingly.
FitWood cannot be held responsible in any way for any loss or injury, howsoever caused, as a result
of neglecting the instructions, misusing the product or misunderstanding the information contained
in this document or on our website.
Warranty applies only for the defects in the product and in case of complaint only the product
or its component will be replaced. The warranty does not cover damage due to negligent use of
the product, natural wearing of the product material or features, or breakage that is caused by an
unfavorable environment. FitWood Ltd will not be liable for any injury or death resulting from
improper assembly, maintenance or use of this product. FitWood's warranty is limited only to
repairing or replacing a faulty product.
For the assembly you will need
• Power Drill or manual screwdriver with Torx TX30 Drill Bit
Make sure you have the following parts
2
Assembly instruction
Always fasten the screws slowly and firmly. However, do not mount the screws too deep and tight.
Remember, that the material is wood, and may crack if you are using too much power. Once the
climbing arch is fully assembled, check that all the screws are fully fastened.
- Assemble the climbing arch on a soft surface, such as cardboard or a carpet.
- Remove all wrapping material before you start the assembly.
- Organize all parts in advance and make sure you have all the required pieces.
- Keep hardware parts out of reach of children.
Step 1
Cover the floor so that the floor or climbing arch will not get scratched during the assembly. Lay the
backboard on the floor so that the screw holes are facing upwards.
Step 2
Screw all the rungs into the backboard. Avoid using unnecessary force and fixing the rungs too tight.
EN
3