Memco Avire Guide D'installation page 2

CONNECTIONS
C B
CONNECTOR
A PWR
B USB
TEL1/TEL2
C
D Antenna
SIM
E
F Switch
INSTALLATION
1. Location: It is recommended that the device be installed at the highest point
(e.g. motor room or top of shaft)
2. Connect the GSM antenna to the SMA connector being careful not to over-
tighten. The antenna should be placed a minimum of 3 metres from the
GSM unit
3. Insert the SIM Card into the SIM holder. Be sure the SIM is inserted in the
correct orientation with the gold contacts facing downwards.
4. Connect the Emergency Telephone to the TEL1 connector. If connecting
more than one emergency telephone, either daisy chain the connection
between the telephones or use a junction block to split the connection from
the device.
5. Connect the power supply cable to the GSM (see 'POWER' below).
6. Turn the GSM Gateway on using the switch on the side.
It is possible to connect up to eight Memcom
GSM; however a power connection should only be made to one of these
Memcom units.
+
POWER
The battery backed +12V power supply from the Memcom
+12V core sleeved red, and a 0V core is sleeved black. This cable is then connected to the travelling cables to take the
power supply to the GSM terminal. The maximum resistance for each core is 1ohm. Use more cores in parallel if it is a very
long run and the resistance is higher than 1ohm.
A grey connector is provided with the GSM to allow you to make the connection to the Memcom
Supply Connection on Memcom
NOTE: If you require a GSM suitable for use with other Emergency Telephones see the Avire '2G Universal GSM' (part
number 452 002).
D A
DESCRIPTION
Power supply connection
USB connector for upgrades
RJ11 FXS connectors
SMA/f connector for external GSM antenna
SIM connector
Switch for the device power off-on
Emergency Telephones to the
+
is used to power the GSM. The power cable provided has a
+
+ ).
E
Emergency Telephone
Power supply connection on Memcom
F
Power
+
(see above 'Power
+