RAB SFL1-LED Instructions D'installation

SFL1-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result
in serious injury or death. Only qualified electricians should install this fixture and the installation MUST conform to
the Canadian Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and
equipment are used to complete the installation.
SAFETY
•
Proper grounding is required to ensure personal safety.
•
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
•
Do not use this equipment for anything other than its intended purpose.
•
Servicing this equipment should be performed by qualified service personnel.
•
Save these instructions.
•
MIN 75 °C SUPPLY CONDUCTOR
TOOLS
•
Allen key set, open-end wrench, Phillip screwdriver, Drilling tool (optional).
INSTALLATION
SLIP FITTER:
1. Remove the bracket mounting screws on the fixture and run the wires
through the bracket.
2. Install the bracket on the fixture.
3. Loosen the 4 locking bolts on the slip fitter, connect the wire correctly
and put the wire into pole. Then fasten the locking bolts between slip
fitter and the pole.
4. Loosen the fixing bolts and adjusting bolts, align the fixture to
required angle. Tighten adjusting bolt and fixing bolts after the angle
is confirmed. Note: Adjustable angle is 0-90°.
RAB Design Lighting inc.
READ, UNDERSTAND
before installing the equipment.
May– 2022
FOLLOW
, and these instructions
Page 1 of 2