RAB SQ-LED Instructions D'installation

SQ-LED & SQJ-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious injury
or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian Electrical Code Part
I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to complete the installation.
SAFETY

Proper grounding is required to ensure personal safety

Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.

Do not use this equipment for anything other than its intended purpose.

Servicing this equipment should be performed by qualified service personnel.

Save these instructions
INSTALLATION

Loosen the screw on the side fixture

Slide the mounting plate out from the mounting plate on the top
of the fixture

Install the mounting plate to a certified outdoor weatherproof
junction box with screws (not provided)

Dangle the fixture on the mounting plate

Make appropriate wiring connections as per wiring diagram

For power supply connections use wire rated for at least 100°C

Gently pull up the fixture against the mounting plate and slide
fixture until it locks into place

Tighten the screw to secure the fixture
WIRING

Check that the line voltage is correct.

Connect fixture GROUND (green) wire to power supply GROUND (green)
wire.

Connect fixture WHITE wire to power supply NEUTRAL wire.

Connect fixture BLACK wire to power supply LINE wire

If the fixture includes 0-10V dimming functionality, connect GREY and
VIOLET wires to the dimming controller.
RAB DESIGN LIGHTING INC.
READ, UNDERSTAND
before installing the equipment.
01/02/2018
FOLLOW
, and these instructions
MOUNTING
PLATE
SCREW
2
1
1