Sanus VisionMount XF228 Manuel D'instructions page 9

2
Wall Mounting
Solid concrete or concrete block
2-1
Mark the wall
2-2
Drill pilot holes
2-3
Insert anchors and lag bolts
6901-002115 <01>
[01]
[25]
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Level the wall plate [01] and mark the hole locations.
CAUTION:
Mount the wall plate [01] directly onto the concrete surface.
Ù
Minimum solid concrete thickness: 8 in.
Ù
Minimum concrete block size: 8 x 8 x 16 in.
Ù
Drill pilot holes as illustrated.
CAUTION:
Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.) using a
Ù
10 mm (3/8 in.) diameter drill bit.
Never drill into the mortar between blocks.
Ù
89 mm
(3.5 in.)
002862.eps
Insert lag bolt anchors [25]. Then insert lag bolts [23] through the
wall plate [01] and into the anchors.
CAUTION:
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage:
[01]
[24]
[23]
13 mm
(1/2 in.)
Avoid potential injuries or property damage!
Avoid potential injuries or property damage! :
Avoid potential injuries or property damage!
ÙBe sure the anchors [25] seat
flush with the concrete
surface.
ÙTighten the lag bolts [23]
only until the washers [24]
are pulled firmly against
the wall plate [01].
ÙDO NOT over-tighten the lag
bolts [23].
002862.eps
10 mm
(3/8 in.)
9