Table des Matières
Publicité
Operating Instructions
Initial Start Up
1.
Disconnect tools and/or accessories from the air hose.
2.
Open the tank drain valve to allow air to escape preventing air pressure
buildup in the air tank.
3.
Check to see that the belt is installed properly with the correct tension.
4.
Plug power supply cord into proper power source receptacle. (See Grounding
Instructions)
5.
Run the compressor for a minimum or twenty minutes in this no-load position
to lubricate the bearings and piston.
6.
Turn off compressor, drain liquid from tanks and close drain valve.
7.
The compressor is now ready for use.
Start Up
1.
Slowly open tank drain by turning clockwise. Allow any water in tank to drain
out. Close fitting securely.
2.
Before starting the compressor, check for broken components and
accessories, and check for damage to the hose.
3.
Make sure the power switch is turned "O"(OFF) position.
4.
Attach desired tool to the end of the air hose.
5.
Turn the switch on the "I"(ON) position.
6.
Adjust regulator knob to desired pressure level once the pump has shut off
and the compressor has stopped running.
Storage
1.
Disconnect tools and/or accessories from the air hose.
2.
Locate drain valve on bottom side of tank.
3.
Open drain valve to release remaining pressurized air and moisture from the
air tank. Moisture buildup in the tank is normal with air compressors, so a
small amount of water may come out while draining the tank. Draining the
tank is vital for longevity and safety of your air
4.
Close valve and store the compressor in a cool, dry place.
Shut Down
1.
Turn the ON/OFF lever to the OFF position.
2.
Rotate the pressure regulator knob counterclockwise until it is fully closed.
Check regulated pressure gauge to ensure that it reads 0 PSI.
3.
Remove air hose and other connected accessories.
4.
Slowly open air tank drain valve to release remaining pressurized air, and tilt
unit to fully drain accumulated liquid from air tanks. Moisture build-up in the
tank is normal with air compressor, so a small amount of water may come out
while draining the tank. Draining the tank is vital for the longevity and safely of
your air compressor.
5.
Close drain valve.
6.
Allow compressor to cool down.
7.
Clean and store compressor.
14
operation
compressor.
Publicité
Table des Matières
