Assembly Instructions; Assembly - New Holland BNAC658HB Mode D'emploi

Assembly

Read all safety instructions before using air compressor.
The compressor is shipped without oil in the crankcase.
Add oil as indicated below.
Check Oil
Level Daily
1. After opening the carton, please remove all parts and check against
photograph on carton.
2. Place air compressor on a flat, level surface.
3. Pour supplied oil into crankcase until the oil level reaches the red dot in
the oil level sight glass. Be careful not to overfill.
4. Adjust tension of belt to ensure that a maximum of 1/2" / 12mm of
slack exists when pressure is placed on belt at centre line.
the belt is installed too tightly, overloading of the motor will occur. This
will cause the motor to overheat. If the belt is installed too loosely, it
will slip and unstable operation and vibration will occur. Caution - The
rotating direction for the flywheel must follow the
belt guard.
5. Close tank drain valve on the bottom of the air tank by turning the valve
clockwise until fully closed.
6. Attach the air coupler to the compressor regulator valve. Use Teflon
thread-sealing tape on the threads to make sure you have an airtight
connection. Do not over tighten fittings.
7. Attach the supplied air filter to the air intake port on the pump head.
8. Attach air hose and any desired air accessories (which are not
cluded). Use Teflon thread-sealing tape on the threads to make sure you
have an airtight connection. Do not over tighten fittings.
Do not operate the compressor without lubricant or with low lubricant
level. We are not responsible for damage caused to the compressor due
to operation without proper lubrication.
12

assembly instructions

WARNING
Oil Level OK
Refill Oil
Immediately
1/2"
NOTICE
NOTE: If
arrow shown on the
in-