Fitting Instructions - Bort SellaFlex Sport Mode D'emploi

– whilst wearing the support, please neither use any creams nor ointments on or
around it as they can destroy the material

Fitting instructions

Important: When you receive your thumb support, the supporting module for use
on the right hand is inserted. The attachment Stabilo strap module 1 is attached to
the support in the supporting module 2 .
Place the support on the metacarpophalangeal joint affected and guide the thumb
through the intended thumb opening at the same time.
1
Stabilo strap with the easyClick system for additional stabilisation of the wrist:
1 and 3 attachment module, 2 supporting module, 4 adjustment
module.
Adapt the stabilisation degree of the Stabilo strap by moving the adjustment
module 4 individually.
2
Guide the Stabilo strap circumferentially around the wrist under slight tension.
Close the strap by attaching the free attachment module 3 to the
adjustment module 4 . Pay attention to comfortable fitting of the Stabilo strap,
neither too loose nor too tight.
3
Left hand thumb support: If the thumb support with the Stabilo strap is
needed for use on the left hand, hang the Stabilo strap out of the support.
Remove the supporting module 2 from the velour bag and slide it into the velour
bag on the opposite side. The supporting module should always be located on the
lower side of the arm towards the palm.
If the Stabilo strap with the easyClick system is not needed, the supporting
module 2 can be taken from the velour bag.
Removal
To remove the strap hang the Stabilo strap with the easyClick system out on the
upper side. Then grasp the support in the palm area and pull it off over the fingers.
EN
09