Fitting Instructions - Bort EpiBasic Sport Mode D'emploi

Fitting instructions

Place the support on the elbow affected and position the knitted green comfort zone
in the antecubital fossa at the same time. The support is correctly positioned if you
can feel the outer and inner condyle through the hollows in the silicone insert.
1
Stabilo strap with the easyClick system for individual dosage of the pad pressure:
1 and 3 attachment module, 2 supporting module, 4 adjustment module.
Adapt the pad pressure dosage individually by moving the adjustment module 4 .
2
When you receive your support, the attachment Stabilo strap module 1 in
the supporting module 2 is attached on the support.
Guide the Stabilo strap circumferentially around the lower arm under slight tension.
Close the strap by attaching the free attachment module 3 to the adjustment
module 4 . Pay attention to comfortable fitting of the Stabilo strap, neither too loose
nor too tight.
If the Stabilo strap with the easyClick system is not needed, the supporting module 2
can be taken from the velour bag.
Removal
After opening the Stabilo strap, take hold of the lower edge of the support and slip
the support over the lower arm in the direction of the hand.
Material composition
Polyamide (PA), elastane (EL), silicone (SI)
The sewn in textile label provides the precise material composition.
Cleaning information
Delicate wash 30 °C
Do not iron
Do not use fabric conditioner. Stretch back into shape and dry in the fresh air.
Do not bleach
Do not clean chemically
Do not dry in a tumble dryer
EN
09