Allen + Roth 1142VA-36-201 Mode D'emploi page 4

VANITY INSTALLATION INSTRUCTIONS
2. Clean area where the vanity (A) will be
permanently located prior to beginning
installation, ensuring the vanity (A) will not
interfere with any water supply and drain lines
once mounted.
Locate wall studs and mark locations. With the
help of another adult, place completed Vanity
Cabinet Assembly to its final location. Adjust
the height of the Vanity Cabinet (A) by
twisting the adjustable leveler foot pins on the
bottom of each leg. Twist clockwise to
decrease height or twist counter-clockwise to
increase vanity height.
Using hardware appropriate for your wall type
(not included), secure Vanity Cabinet (A) to
two wall studs anywhere through the Vanity
Mounting Plates. Be careful not to disturb
any electrical or water lines that may be
concealed in the wall.
WARNING
Vanity (A) MUST be secured to the wall.
3. Apply silicon adhesive (not included) to the top
of triangle connection blocks, With the help of
another adult, gently lower the stone top with
assembled sink onto the cabinet, make sure
the stone top is flush with the back side of the
wood cabinet and the stone overhang is equal
on both sides over the wood cabinet left and
right side walls.
Tip: it may be easier to install the faucet and/or
drain assembly (not included) before
securing the stone top to the wood cabinet.
1328VB-48-242
2
A
2026VA-36
3
2
A
4
1
B
2