Palram CANOPIA 705782 Mode D'emploi page 7

INSTALLATION
1.
The heater must be installed under a ceiling or on a wall at least
1.8 metres above from the floor. When installing the heater, please
keep a distance of at least 20 cm from every direction. Please keep
away from flammable materials.
2. Options 1: Wall / Ceiling, drill 2 holes on the ceiling or wall. Insert
the 2 expansion bolts into the holes. Use a spanner to twist the
screw nuts on the expansion bolts clockwise till they are securely
located in the holes. Unscrew the screw nuts and put them aside
with washers, spring washers for further use later.
Option 2: Product's profile, drill 3 holes using drill screws in order to
secure the bracket on to the profile.
3.
Put Steel Board onto the ceiling or wall. Let the 4 Expansion Bolts
go through the 4 holes on Steel Board and fix it with the Washers,
Spring Washers and Screw Nut above mentioned.
4.
Mount the heater onto the wall or ceiling by sliding Upper Bracket
into the open on Steel Board. Fix them together with screw M8 x 75
and M8.
5.
Use a screw driver to unscrew the Screw M8 x 75 a little bit. Set
the heater to a desired angle and drive Screw M8 x 75 tight. The
adjustable angle is within 60 degree totally.
EN ELECTRIC IP65 WATERPROOF OUTDOOR CARBON FIBER HEATER WITH WALL/CEILING MOUNT
OPERATIONS
1.
Plug in the unit to a socket. Make sure the power supply is
same as rated.
2.
Press Switch on left side of the heater to switch on/off the
heater as desired.