Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Using the enclosed mounting template,
2
place the diagram against the wall and mark
four locations on the wall where the mount
is to be Installed.
With the help of another person, place the
3
mount against the wall and level it using the
bubble guide.
While another person holds the mount
4
in place, mark four locations on the wall
where the mount is to be installed.
Set the mount aside and drill a 3/8" (10
5
mm) pilot hole at each marked location.
Remove any excess dust from the holes.
Insert a Concrete Anchor (P) into each
6
hole so that it is flush with the concrete
surface. A hammer can be used to lightly
tap the anchors into place if necessary.
Place the mount back against the wall and
7
secure it using the lag bolts (Q) and lag bolt
washers (R) provided. Do not over-tighten
these bolts and do not release the mount
until all bolts are in place.
Once all (4) lag bolts are in place you must
8
tighten each one. Be sure not to over
tighten.
2
D
Note
If the concrete wall is covered
by a layer of plaster or drywall,
the concrete anchor must pass
completely through the layer to rest
flush with the concrete surface.
6
3.3 Attaching the arms to the display
B
Warning
Use extra care during this part of the
installation. If possible, avoid placing
your display facedown as it may
damage the viewing surface.
D
Note
Your mount comes with a selection
of bolt diameters and lengths
to accommodate a wide variety
of display models. Not all of the
hardware in the kit will be used.
Determine the correct length of bolt to
1
use with your display by first examining the
back of your display.
A. If your display has a flat back: You will
use one of the shorter bolts (A, D, G, or J)
from the hardware kit.
2
B. If your display has a curved or
recessed back: You will use one of the
longer bolts (B, E, H, or K) along with a
spacer (M or N).
3
4
3
4
Publicité
Table des Matières
