Klarfit Husky Mode D'emploi page 12

EN
12
If the trailer frame is lying fl at, lift the side walls so that they are vertical.
Position the roll bar so that the holes in the side walls and the holes in the ends
of the roll bar are aligned (1). Insert the button from the outside on the side
wall and then into the thread at the end of the roll bar. Repeat for the other
side and tighten both buttons (2).
ATTACHMENT TO BICYCLE
Note: The universal coupling is only suitable for bicycles with full axle and/
or with quick-release axle.
Bicycles with full axle
Remove the left axle nut from the bicycle. Any spacers or washers can be
retained. Place the clutch on the axle and reinsert the nut.
WARNING
Risk of injury! The axle nut must be tightened at least 5 full
turns on the axle thread to ensure suffi cient clamping force.
Too short a thread can lead to unintentional loosening of the
rear wheel and thus to serious injuries or death. If in doubt,
contact your dealer.
3