Saba LVS14C45MI17GLB Mode D'emploi page 42

estimate the amount from the colour of the optical level indicator
"C" located next to the cap. When the rinse-aid container is full,
the whole indicator will be dark .As the rinse-aid diminishes, the
size of the dark dot decreases. You should never let the rinse aid
level fall 1/4 full.
As the rinse aid diminishes, the size of the black dot on the rinse
aid level indicator changes, as illustrated below.
Full
3/4 full
1/2 full
GB
1/4 full - Should refill to eliminate
spotting
Empty
1. To open the dispenser, turn the cap to the "open" (left) arrow
and lift it out.
2. Pour the rinse aid into the dispenser, being careful not to
overfill.
3. Replace the cap by inserting it aligned with "open" arrow and
turning it to the closed (right) arrow.
80
C (Rinse-Aid indicator)
NOTE: Clean up any rinse aid spilled while during filling
with an absorbent cloth to avoid excessive foaming during the
next wash. Don't forget to replace the cap before you close
dishwasher door.
Adjusting Rinse Aid Dispenser
Adjust lever (Rinse)
The rinse aid dispenser has six or four settings. Always start
with the dispenser set on "4". If spots and poor drying are
a problem, increase the amount of rinse aid dispensed by
removing the dispenser lid and rotating the dial to "5". If the
dishes still are not drying properly or are show spots, adjust the
dial to the next higher lever until your dishes are spot-free. The
recommended setting is "4". (Factory value is "4".)
NOTE: Increase the dose if there are drops of water or lime
spots on the dishes after washing. Reduce it if there are sticky
whitish stains on your dishes or a bluish film on glassware or
knife blades.
D. Function of Detergent
Detergents with its chemical ingredients are necessary to remove
dirt, crush dirt and transport it out of the dishwasher. Most of the
commercial quality detergents are suitable for this purpose.
GB
81