MESTIC Barbecue best chef MB-300 Mode D'emploi page 9

Gas connection
The device burns on propane / butane gas G30.G31 and is suitable for connection through a propane gas hose that
conforms to EN 559 or EN1763. Connect the rubber hose to the connecting piece of the device with a quarter-left
connection or a hose clamp. The gas hose may be a maximum of 150 cm long. Before installation, check whether the
operating pressure of the gas pressure regulator corresponds to the operating pressure of this appliance as stated on
the nameplate. Check all gas connections for leaks by means of a gas leak spray or soapy water. Never use an open
flame
Technical data
Country of Catergory/ies
destination
BE, CH, CY, CZ, ES, I3+
FR, GB, GR, IE, IT, LT,
LU, LV, PT, SI, SK, TR
BE, BG, CY, CZ, DK, I3B/P
EE, FI, FR, GB, GR,
HR, HU, IT, LT, LU, LV,
MT, NL, NO, RO, SE,
SI, SK, TR
AT, CH, CZ, DE, LU, I3B/P
SK
PL I3B/P
How to use
1. Turn all adjustment knobs to the lowest position (zero).
2. If the device has a lid, open it carefully
3. Connect the controller correctly.
4. Perform a leak test before using the device.
5. Fully open the tap on the gas bottle.
6. The device is operated by turning the adjustment knob. Press the button and turn it carefully to the left until
you hear a click. If the gas burner does not ignite, turn the knob slower until it clicks. This gives the gas more
time to reach the gas burner.
7. When the gas flame is burning, it can be adjusted to the desired height.
8. If the gas stove does not work properly or if a gas smell is detected, immediately close the gas tap on the gas
bottle.
After use
Close the tap on the gas bottle after use. Then close the barbecue tap by turning it clockwise with this pointer to the
closed position.
Changing the gas bottle
1. The gas cylinder may only be exchanged in the open air and away from combustible materials.
2. Check the bottle tap and appliance tap are completely closed.
3. Unscrew the gas pressure regulator from the gas bottle.
4. Before reassembling the gas pressure regulator, check whether the rubber inlet ring is still present and
undamaged.
5. Screw the swivel of the gas pressure regulator tightly onto the threads of the cylinder valve.
Type of gas Supply
pressure (mbar)
G30/G31 28-30/37
G30/G31 30
G30/G31 50
G30/G31 37
Injector size Heat input
(mm) (kW)
0.97 4.0
0.97 4.0
0.83 4.0
0.89 4.0
ENGLISH
Gas consumption
(g/hr)
290
290
290
290