Speci Cations; Battery Indicator; Charging The Battery Pack - Ravpower RP-PB063 Guide D'utilisation

Speci cations

Model RP-PB063
Battery Capacity 14000mAh
DC 5V / 2.1A
Input
iSmart USB Output 1 DC 5V / 2.1A Max
iSmart USB Output 2 DC 5V / 2.1A Max
Quick Charge 3.0 Output DC 3.6V - 6.5V / 3A, 6.5V - 9V / 2A, 9V - 12V / 1.5A
Starting Current 800A
Peak Current 1000A
Recharging Time Approx. 6.5 hours
Operating Temperature -20°C to 60°C / - 4°F to 140°F
Net Weight (Battery Pack) 580 g / 20.5 oz
Dimensions 20.8 x 8.0 x 3.8 cm / 8.2 x 3.1 x 1.5 in

Battery Indicator

The battery status indicator has 4 levels, which is based on the current battery level:
Battery Status Indicator Battery Level
0 - 25%
26% - 50%
51% - 75%
76% - 100%

Charging the Battery Pack

There are three ways to charge the battery pack:
• Connect the battery pack with a power outlet using a 5V / 2.1A power adapter.
• Connect the battery pack with the car cigarette lighter using the included USB cable.
• Charge with the wall charger included in the package.
Jump Starting Cars
The battery pack can be used to jump start gasoline powered engines with a 12V battery.
1. Check the battery level via the Battery Indicator by pressing the Power Button once and
make sure at least 60% power remains.
2. Connect the jumper cable with the car battery terminals (Red is positive and black is negative).
3. Plug the jumper cable into the battery pack.
4. Start the car by turning on the ignition.
5. Disconnect the car battery as soon as the car has started.
Note:
When the car battery voltage reaches a level between 10.5 + / 0.3V to 12.6 + / 0.3V, the
Status Indicator lights up in green, which indicates the car battery works normally. When the
voltage is below 10.5 + / 0.3V, the indicator lights up in red. Press the Boost Button to jump
start the car.
Charging Mobile Devices
• Use any of the three USB charging ports to charge mobile devices, such as smartphones
and tablets. Use the QC 3.0 port to charge QC compatible devices at full speed and other
non-compatible devices at normal USB speed.
Connect the battery pack to your device and charging will start automatically. If nothing
•
happens after connecting your device, press the Power Button to restart the battery pack.
• Power will automatically cut off after 30 seconds if no devices are connected.
LED Flashlight
Press and hold the Power Button to turn on the flashlight. Once the flashlight mode is
triggered, press the Power Button to cycle through SOS, Warning, and OFF mode.
03/04