Sharper Image PURIFY 3 Guide De L'utilisateur page 6

7. Appuyer doucement sur le périmètre du filtre pour s'assurer qu'il est bien en
place.
8. Réinstaller le filtre à charbon actif.
9. Pour remplacer le pré-filtre permanent, vous devrez peut-être fléchir
légèrement le pré-filtre permanent pour insérer les languettes sur les côtés.
10. Remettre le panneau avant. L'appareil fonctionnera seulement si le panneau
avant est placé correctement.
11. Pour réinitialiser l'avis de
remplacement des filtres,
garder la touche REPLACE
CARBON (remplacement
du filtre au charbon)
ou REPLACE HEPA
(remplacement du filtre
HEPA) enfoncée pendant au
moins 3 secondes ou jusqu'à
ce que le bouton ne soit plus
allumé.
50 Français
- Clean your product regularly, only as is instructed in this manual. Prior
to cleaning, turn off the power on your product and unplug. Do not
use gasoline, thinners, solvents, ammonias or other chemicals for
cleaning. Refer to the CLEANING instructions provided.
- Do not open appliance housing while product is plugged in. To avoid
risk of shock, all service and/or repairs must be done by contacting
(833.800.8669) or (help@sihomecomfort.com).
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Contact Customer Service or dealer or an experienced radio/TV
technician for help.
English 7