Installation And Wiring - LEGRAND Wattstopper TDR Instructions D'installation

Masquer les pouces

Table des Matières

Les langues disponibles

For ease of installation, manufacturer recommends use of a deep wall box.

1. Prepare the switch box.

After the power is turned OFF at the circuit breaker box, remove the

existing wall plate and mounting screws. Pull the old switch out from

the wall box.

2. Identify the type of circuit.

The TDR can only be used in conjunction with a Touch Dimmer or Touch Fan Speed Control on 3-way/multi-way circuits.

In a 3-way circuit (Fig. 2) two traveler wires connect to both switches. Another wire provides power from the circuit box to one of the

switches. A wire connects from one switch to the load. A ground wire may also be connected to a ground terminal on the old switches.

Caution – For your safety: Connecting a proper ground wire to the dimmer provides protection against electrical shock in the event of

certain fault conditions. If a proper ground is not available, consult with a qualified electrician before continuing installation.

3. Prepare the Wires.

Tag the wires currently connected to the existing

switch so that they can be identified later. Disconnect

the wires. Make sure the insulation is stripped off of

the wires to expose their copper cores to the length

indicated by the "Strip Gage" in Fig. 3. (approx. ½

inch).

4. Wire the Touch Remote.

The wiring diagrams that follow are for the Touch

Remote only. When connecting the Touch Remote to

a Touch Dimmer or Fan Speed Control, refer to that

device's specific installation instructions.

Fig. 3 : #12 or #14 AWG

a. 3-Way/Multi-Way Wiring (Fig. 4)

NOTE: In a 3-way/multi-way circuit the TDR must be

used in conjunction with the TDR-603, TDA-603,

or TDFC-1A. The TDR does not work if used in

conjunction with standard 3-way/4-way switches.

• Connect the green or non-insulated (copper) GROUND

wire from the circuit to the green wire on the Touch

Remote. The TDR requires a ground. Be sure to verify

the ground connection.

• Connect the yellow traveler wire from the Touch

Dimmer or Fan Speed Control to the gold terminal on

the Touch Remote.

b. Three or More Locations (Fig. 5)

• Connect the green or non-insulated (copper) GROUND

wire from the circuit to the green wire on the Touch Remote.

The TDR requires a ground. Be sure to verify the ground

connection.

• Connect the yellow traveler wire from the Touch Dimmer or Fan

Speed Control to all the Touch Remotes.

5. Put all the new switches into their wall boxes. Position the

Touch Remote with the word TOP in the correct orientation. Use

the captive screws on the mounting strap to secure the Touch

Remote to its wall box.

6. Restore power to the circuit. Turn on the breaker or replace the

fuse.

7. Attach the cover plates.