Taurus BLACK GLASS Ver II Mode D'emploi page 13

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
5. Now that the hood is hung, you must fix the
one-way valve to the air outlet as follows:
6. Connect the exhaust pipe to the air outlet of
the extractor hood as follows:
NOTE: It is recommended to use American tape
to fix and better seal the exhaust pipe around the
air outlet.
7. Place the lower chimney on the hanged hood
with the small chimney hanger placed on the
back, mark two points on the wall in the position
of the chimney hanger holes.
8. Remove the lower chimney and drill two 8 mm
holes and fix the small chimney hanger with two
screw plugs and two screws.
9. Place the upper chimney in the lower chimney
and place them over the hood and hang the
lower chimney on the small chimney hanger.
10. Pull the upper chimney up until it reaches the
required height and mark the points of the large
chimney hanger on the wall.
11. Drill two 8 mm holes and secure the large
chimney hanger with two screw plugs and two
screws.
12. Hang the upper chimney to the large
chimney hanger.
NOTE: You can also fix the upper chimney with
two small screws (3X10) as follows:
NOTE: If you don't have an outlet to the outside,
the exhaust pipe is not necessary and the
installation is the same as before skipping the
part of the pipe (recirculation mode).
You will need two carbon filters to trap odours,
they are not included.
To install the carbon filters, remove the grease
filters as explained above, plug the filters into the
unit and turn them clockwise on both sides of the
motor, as shown below:

Publicité

Table des Matières
loading

Table des Matières