Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Location of Control
1. Alarm 1 indicator
2. Alarm 2 indicator
3. USB charging port
4. DC5V jack
5. VOLUME - / ALARM 2 button
6. VOLUME + / ALARM 1 button
7.
POWER ON/OFF / ALARM
OFF / MODE button
8. HOUR / TUNING < button
9. MINUTE / TUNING > button
10. TIME / MEMORY button
11. SNOOZE / SLEEP button
Power Supply
Mains supply :
Insert the AC adaptor into a 230V AC ~ 50Hz mains outlet and the other end
of the cord into the DC 5V jack on the back of the unit.
Battery back up :
failure by 2 x AAA/ LR03 batteries (not supplied).
Once the power is restored, check the time to make sure it is accurate and re-set if necessary.
Inserting the Batteries
1.
Open the battery compartment at the bottom of the unit by pressing on the catch and
removing the cover.
2.
Insert 2 x AAA/ LR03 batteries (preferably alkaline batteries) into the battery compartment,
following the polarity as shown on the diagram inside the compartment.
3.
Replace the battery compartment cover
Setting the clock and alarm
Setting the Clock
1.
Press and hold the TIME button and the hour/minute digits will flash.
2.
Use the HOUR button to set the hours. The PM indicator will light when the hour is
advanced into the PM time.
3.
Use the MINUTE button to set the minutes.
4.
Press the TIME button to confirm.
Setting the alarm
Before setting the alarm time, make sure the Clock has been set.
1. In standby mode, press and hold AL1 / AL2 until "0:00" flashes on the display.
The clock time and alarm (if set) can be maintained during a power
EN
1
Publicité
Table des Matières
