IVT EHK-130G Mode D'emploi page 9

Switching Off
Release the On/Off switch (1) to turn off the tool.
OPERATING INSTRUCTIONS [F1]
WARNING! Do not use the tool with
the scale bracket (4) out of position.
Always position the scale bracket (4)
so it abutting with the piece to be cut.
Serious injuries and burns may occur.
1. Connect the plug into an appropriate electrical
outlet.
2. Turn the selector knob (2) to the desired
temperature.
3. Press and hold the On / Off switch (1) to heat up
the blade (3); the blade (3) will reach the operating
temperature in about one minute and will remain at
the temperature selected. The led will illuminate during
operation.
4. When the blade (3) has reached the temperature,
you may use the sharp edge of the blade (3) for line
cutting or use the side of the blade (3) for wide groove
cutting.
5. When pressure on the On/Off switch (1) is released,
the blade (3) will cool down gradually. Turn off the tool
and unplug it from its electrical outlet.
WARNING! The residual heat on the
blade (3) takes several minutes to
dissipate. Use caution while the blade
(3) is still hot.
Adjusting the cutting depth
The cutting depth of the tool may be adjusted using the
scale bracket (4). To adjust the depth, loosen the two
clamping screws (5). Pull out or retract the scale bracket
(4) to the desired cutting depth. Then retighten the two
clamping screws (5).
ATTENTION! DO NOT ATTEMPT TO REPAIR THE PRODUCT BY YOURSELF AND DO NOT
TAMPER WITH IT! Any operation of repairing or extraordinary maintenance must be carried
out only by a qualified and authorized IVT Service Center. Do not try to modify any internal
part of the product! THIS WILL COMPLETELY VOID THE WARRANTY AND IT COULD CAUSE
SERIOUS INJURY AND DAMAGE.
MAINTENANCE AND STORAGE
Before any work on the device itself,
pull the mains plug.
∙ Always keep the tool and the ventilation slots (if
present) cleaned. Regular cleaning and maintenance of
the appliance will ensure efficiency and prolong the life
of your tool.
∙
If the tool should fail despite the rigorous
manufacturing and testing procedures, the repair should
be carried out by an authorized IVT customer service.
∙
Keep all nuts, bolts, and screws tight, to be sure the
tool is in safe working condition.
∙
Replace worn or damaged parts for safety.
∙
Use only original spare parts. Parts not produced
by manufacturer may cause poor fit and possible injury.
∙
Store the tool in a dry room out of reach of kids and
away from any flammable material.
∙ Never wet the device or spray water on it!
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of
disposing as waste.
Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labeled for categorized
recycling. These instructions are printed on recycled
paper manufactured without chlorine.
9
Instruction manual
EN