Accessories' Application - LAVOR Pro GV KONE Mode D'emploi

All manuals and user guides at all-guides.com
• The steam nozzle must not be obstructed.
- Press the main switch (4); the indicator lights
(4/B and 5) come on (heating begins).
- The machine is in operation.
- Water is heated and steam is generated.
- When the green lamp lights up (3) the machine
is ready to work.
Pouring water into the boiler
WARNING!
• When the machine is in use, don't open the
boiler cap (9)! Danger of scalds!
NOTE:
• When the boiler water is finished, the orange
water indicator lamp (6) will light up.
Filling
• After the orange "no water" light (6) comes on,
make sure that the machine no longer supplies
steam (keeping the control device (12) open) by
repeatedly activating the steam lever (1).
• Disconnect the main switch (4) (OFF position).
• Remove the electrical plug (10) from the supply
socket.
• Let the steam cleaner cool down until the index
reaches the yellow area.
• Press the boiler cap (9) downwards and turn
it anticlockwise at the same time, so as to
unscrew it completely.
• Pour water into the boiler.
• Put the cap (9) on the boiler: press it downwards
and turn it clockwise at the same time, so as to
screw it tight.
Disconnecting the steam cleaner
• Disconnect the main switch (4) (OFF position).
• Pull out the electrical plug (10) from the supply
socket.
• Let the steam cleaner cool down.

ACCESSORIES' APPLICATION

Fitting or removing accessories
•DANGER!
• Never work with wet hands. Electric current:
Danger of death!
• The steam cleaner must be disconnected
before removing the accessories.
• Accessories get hot when the machine is
working. Let them cool down before carrying
out any replacement. Be careful when replacing
the accessory during operation: danger of
scalds.
Fit the extension pipe
• Press the spring button (18) on the steam
nozzle handle (19)
• Fit the steam nozzle handle (19) into the sleeve
of the extension pipe (17) until the spring
button (18) snaps into place.
Fitting the brushes
(fig. D)
• In order to be able to use the rectangular or the
triangular scrubbing brush, it is necessary to
connect the brush-joint (16) first:
- Keep the brush-joint pointed downwards and
insert it firmly into the brush. Then turn the
brush-joint upwards.
- Press the spring button (18) on the steam nozzle
handle (19) or on the extension pipe (17).
- Fit the brush-joint (16) into the steam nozzle
handle (19) or into the extension pipe (17), until
the spring button (18) snaps into place.
Removing the pipe or the brushes
• Push the spring button (18) on the steam nozzle
handle (19) or on the extension pipe (17).
• Remove the extension pipe (17) from the steam
nozzle handle (19).
• Keep the brush-joint (16) pointed downwards
and remove the brush from the brush-joint.
Protection cloth
(fig. F)
NOTE:
• Cotton cloths are used to protect surfaces from
scratches. Be careful! Cloths become hot while
you do the cleaning.
•WARNING!
EN
51