Field Of Application - LAVOR Pro GV KONE Mode D'emploi

EN
NOTE:
• The steam jet can't remove any limescale. To
get rid of it, use the descaler.

Field of application

The steam cleaner is suitable for cleaning:
Wide surfaces, such as:
• Tiled floor, parquet, stone and linoleum
floor.
• Wax-treated tiled floor (wax removal)
• Tiles or tiled walls
• Roller shutters, guillotine windows
• Carpets
Small surfaces, such as:
• Interstices of
skirting boards
• Door or window frames
• Shutters
Glass surfaces, such as:
• Windows, glass walls
• Glass doors
• Mirrors
Upholstery, such as:
• Carpets and moquettes
• Upholstered furniture (sofas, airmchairs).
•ATTENTION!
Furniture surfaces can be treated with the steam
cleaner under the following conditions:
• Never clean with the direct steam jet.
• Always use a soft absorbent cloth
• Work with little steam pressure
• When you clean, don't exert any pressure with
the brush.
Assemblying of wheels and handle
• Assemble wheels by hand as shown in picture
on fig. B . No tool is required.
• The handle (13) must be fitted on the upper
part of the appliance with 4 screws (included in
the accessories supplied) (see picture on page
II). You will need a screwdriver for this operation
(not included in the accessories supplied).
50
All manuals and user guides at all-guides.com
heat radiators, tile joints,
Assemblying of the holding hook
• For a comfortable use of the two extensions,
assemble the holding hook (29).
• The holder must be fixed with screws (included
in the accessories) under the extensions (see
picture fig. B)
Starting the steam cleaner
(fig. E)
Fill with water
•ATTENTION!
• Before filling the boiler with water, unplug the
machine.
• Fill in the steam cleaner only with distilled water
or with tap water with low mineral contents.
• The formation of limescale in the machine can
cause the machine to overheat and clog the
steam outlet pipe.
• The steam cleaner must rest on a plane
surface.
- Press the boiler cap (9) downwards and turn
it anticlockwise at the same time, so as to
unscrew it completely.
- Pour a suitable amount of water (min. 0.5 l,
max. 1.6 l) using the provided jug and funnel.
- Put the cap on the boiler: press it downwards
and turn it clockwise at the same time, so as to
screw it tight.
•WARNING!
• Make sure that the boiler cap is properly closed.
Cap loosening during use may cause scalds!
Connecting the steam cleaner
DANGER!
(fig. C)
• Connect the machine only if the mains voltage
matches to the rated voltage marked on the
rating plate.
• The main switch (4) must be disconnected (OFF
position).
• The power cord (10) must not be damaged.
• The water tank must be filled with a sufficient
water quantity (min. 0.5 l) using the special
measuring jug.
• The hose must be connected to the relevant
accessory.