Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

RHB-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
Proper grounding is required to ensure personal safety.
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
Do not use this equipment for anything other than its intended purpose.
Servicing this equipment should be performed by qualified service personnel.
Save these instructions.
INSTALLATION
Before attempting any installation, ensure that the electrical supply is
switched off and the circuit fuses are removed or the circuit breaker is in the
"OFF" position.
Install the mounting plate to a certified junction box with the given
Screws.
OPTION: Fixture can also be pendant or suspended mounted as shown
(Figure 1). Secure the pendant rod or suspended hook to the mounting plate
Hang the fixture on the driver housing. Make connection as per wiring
diagram (Figure 2).
Slide the mounting plate on the driver housing and secure it with the given
screws (Figure 2).
WIRING
Check that the line voltage is correct.
Connect fixture GROUND (green) wire to power supply GROUND (green) wire.
Connect fixture WHITE wire to power supply NEUTRAL wire.
Connect fixture BLACK wire to power supply LINE wire
RAB DESIGN LIGHTING INC.
READ, UNDERSTAND
before installing the equipment.
04/17/2018
FOLLOW
, and
these instructions
PENDANT & SUSPENDED MOUNT (OPTION)
Fig. 1
MOUNTING PLATE
1
Fig. 2
DRIVER HOUSING
2
1

Publicité

loading

Sommaire des Matières pour RAB Design RHB-LED

  • Page 1 Check that the line voltage is correct. • Connect fixture GROUND (green) wire to power supply GROUND (green) wire. • Connect fixture WHITE wire to power supply NEUTRAL wire. • Connect fixture BLACK wire to power supply LINE wire RAB DESIGN LIGHTING INC. 04/17/2018...
  • Page 2 Branchez le fil de VERT du luminaire au fil de TERRE de l'alimentation. • Branchez le fil BLANC du luminaire au fil NEUTRE de l'alimentation. • Branchez le fil NOIR du luminaire au fil de LIGNE de l'alimentation. RAB DESIGN LIGHTING INC. 04/17/2018...