Filling The Boiler With Water - Monster IB 45 LX RAS Perfect Notice D'utilisation

- Slip the iron sheath on the steam generator.
- Insert the iron cord support (8) in the opening of the steam generator and hang the mono-tube (12).
The iron cord support prevent the unwanted movement of the garments as well as the "wear" of the
mono-tube.

2. Filling the boiler with water

The ironing board's boiler can be recharged continuously. When the water is going to fi nish, the signalling
spy turns on and you may continue with the water's insertion without switch off the boiler.
- Carefully remove the cap (1), making sure the steam has completed exhausted.
- Fill the bottle (16) with tap water (untreated).
- Insert the bottle into the opening of the steam generator.
- Thoroughly replace the cap back without tightening it too much (tighten too much is useless and may
cause the wear of the seal).
tap water
Important: the maximum capacity of the steam generator is 1 liter. Do not forget that some water always
remains inside the generator. When you fi ll in the water, the air bubbles inside the fi lling opening of the
steam generator may impede another refi lling. We recommend to gently shake the bottle during the
refi lling. Never fi ll the steam generator under water tap: danger of short-circuit!
Libro 1.indb 22 Libro 1.indb 22
22
gently push
19-09-2007 14:25:58 19-09-2007 14:25:58