Safety Instructions - VGE ECONOMY UV-C Manuel

MANUAL XCLEAR ECONOMY UV-C
Congratulations on the purchase of your new Xclear Economy UV-C! The Xclear
EN
Economy UV-C is designed and manufactured with demanding requirements for quality,
performance and reliability of the system. Every single component has been extensively
tested to ensure compliance with these stringent requirements.

SAFETY INSTRUCTIONS

1. Warning - Due to the risk of injury, this product is not suitable for use by children or
persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience or knowledge, unless they are supervised or instructed on the use
of the device by a person responsible for their safety.
2. Warning - Risk of electric shock. If in doubt as to whether you have sufficient
knowledge and experience, this device must always be connected by a certified
electrician, according to the locally applicable standards and laws, with a properly
earthed connection protected by a residual-current device.
3. Warning - To reduce the risk of electric shock, a damaged cable should be replaced
immediately if possible (Read also number 16).
4. Warning - To reduce the risk of electric shock, the use of an extension lead is not
recommended. Connect the device to an easily accessible mains outlet.
5. Do not bury the connection lead. Never share connections and/or connection leads
with lawn mowers, hedge trimmers or other equipment.
6. Never install the unit at a location where it will be exposed to direct sunlight.
7. Keep children away from this device and the electrical lead.
8. During and after commissioning, the unit is operating and filled with water.
Therefore, to reduce the risk of electric shock, be careful during repairs and/or
service work. If you lack the necessary knowledge and experience, repair and/or
service activities should be performed by authorized/accredited technicians.
9. Never touch the appliance if it falls into the water! Disconnect the connection lead
first, before removing the unit from the water. Because electrical components are
damaged by water and therefore become unsafe, the device must be submitted to
authorized/accredited technicians for repair/maintenance.
10. The device must not be switched on if it has been damaged during or as a result of
transport, a fall, a production defect or other cause (particularly the quartz glass
sleeve and the UV-C bulb).
11. Always connect the device to an undamaged, earthed mains outlet with hinged
cover.
12. Always remove the plug from the outlet when the device is not in use and/or during
cleaning and maintenance activities. The plug must be removed from the mains
| MANUAL XCLEAR ECONOMY UV-C
4
Important read this manual carefully before proceeding
to installation and commissioning.
This device produces harmful radiation. Direct contact can pose a hazard
to eyes and skin. Only check the operation of the UV-C lamp through the
transparent parts of the unit.