Uline H-8456 Guide Rapide page 2

Figure 3
PAGE 2 OF 9
ASSEMBLY CONTINUED
3. Place bottom of legs into shelf bracket collars. Secure
legs to shelf brackets with set screws using 5/32" Allen
wrench. (See Figure 3)
4. Stand assembly upright onto shelf bracket collars.
Figure 4
Place top shelf onto assembly by lining up top shelf
collars with top of legs and sliding into place. Secure
legs to top shelf with set screws using 5/32" Allen
wrench. (See Figure 4)
5. Place overshelf assembly on top of worktable by
Figure 5
lining up shelf brackets with the edge of the table at
each end. Make sure both sides are positioned in the
same area of the table top. (See Figure 5)
6. Mounting collars have two holes on the sides for
Figure 6
securing to table top. Using collar holes as a template,
drill through the side of the table top with supplied
Cobalt drill bit. (See Figure 6)
NOTE: Opening of shelf collars should face the
inside of assembly.
NOTE: It may take a few seconds for the drill bit
to work its way through the stainless material.
0721 IH-8456