Salamander Designs FPS1XL Mode D'emploi page 7

display installation
Attach Brackets to Display
Check depth of screw threads in display before inserting screws.
Inserting a screw that is longer than the hole could result in damage
to display. Depth can be confirmed by inserting hex wrench into hole
and marking its length then confirming this length is sufficient by
comparing it to the screw you are using.
FPS1XL_EL Instruction 4-7-20 Attach Display Brackets
Attach Brackets to Display
(USE ALL TEXT AND UPPER IMAGES FROM 501-680 (07.18) PAGE 7 OF 24)
Install interface mounting brackets (O) onto display as shown using supplied phillips
screws (A-G) or screws specified by the display manufacturer. Hand tighten first
to confirm thread and depth match. Note: Affix display brackets "Ears-Out" as shown
Ears out
Touch Presenter Motorized Mobile Stand